combustion product

美 [kəmˈbʌstʃən ˈprɑːdʌkt]英 [kəmˈbʌstʃən ˈprɒdʌkt]
  • 网络燃烧产物
combustion productcombustion product
  1. Composition , thermodynamic and electrical physical properties of seeded coal combustion product

    添加种子的煤燃烧产物的组分、热力和电物理性质

  2. Laser-induced fluorescence spectra measurement of combustion product components

    燃烧产物组成激光诱导荧光光谱的测量

  3. The experimental results show that with increasing pressure of sample , the porosity of combustion product and the particle size of final tungsten powder decrease .

    随着压坯压力的增加,燃烧产物的空隙率和钨粉颗粒的粒度呈递减趋势。

  4. Classifies the determination methods into those by temperature profiles , visibility profiles and combustion product concentration profiles in terms of characteristic parameters of smoke .

    基于烟气特性参数将烟层界面的判定方法分为温度判定法、能见度判定法和燃烧产物浓度判定法。

  5. The paper selects carbon monoxide as target gas for fire detection according to combustion product in fire , and combines smoke particles to make multiple detection .

    本文从火灾燃烧产物着手进行分析,确立了以CO作为火灾探测的目标气体,并结合烟雾参量构成复合探测。

  6. The powder combustion product was amorphous . It could yields crystalline single phase perovskite after being calcined at 500 ℃ and 600 ℃ .

    混合物在350℃着火燃烧后产物为非晶态,进一步在500℃和600℃焙烧后得到单相结晶钙钛矿相。

  7. The nature of combustion product depends on the magnitude of the field . The strength of diffraction peak of WC in XRD pattern increases with the increase of field strength .

    燃烧产物的特性与场强有关,当场强增加时,X射线衍射图中WC相的衍射峰强度增强,表明碳在钨中的扩散随场强的增强而增大。

  8. Exposure to formaldehyde , a by-product of the combustion product of tobacco smoking , was reported in2008 to be associated with an increased risk of ALS .

    烟草产品燃烧后的一种副产物&甲醛,2008年被报告与肌萎缩侧索硬化的危险性增加有关。

  9. Thirdly , the sulfur distribution characteristics about the combustion product of coal for power plant boiler was investigated . The mathematics model of sulfur emission in fired-bed boiler was established .

    然后对典型电站锅炉燃煤时硫在动态燃烧产物中的分布特征进行了研究,建立了层燃炉硫排放的数学模型。

  10. Dense TiC Ni large scale hard alloys were prepared by self propagating high temperature synthesis and pseudo heat isostatic pressing . Combustion product consisted of TiC phase and Ni binder phase .

    采用自蔓延高温燃烧合成结合准热等静压技术(SHS/PHIP),成功地得到了致密性良好、直径为240mm的大尺寸TiCNi系硬质合金部件。

  11. Characteristics , processing technology , test method and technical index requirements of fire retardant , fire resistant , low smoke , low halogen ( or without ) cables and the cables with low toxicity combustion product have been introduced .

    介绍了阻燃电缆、耐火电缆、低烟电缆、无卤(低卤)电缆、燃烧产物低毒电缆的产品特性、加工工艺、试验方法、技术指标要求等内容。

  12. For the better impetus of methanol gasoline application , combining the characteristic of methanol gasoline and its combustion product , the influence of methanol gasoline on the detergent-dispersant performance of engine oil was studied through the laboratory simulation testing .

    为了更好地推动甲醇汽油的应用,结合甲醇汽油及其燃烧产物的特点,通过实验室模拟试验,研究了甲醇汽油对汽油机油清净分散性的影响。

  13. The paper establishes soft measurement models of Ultimate Analysis of Coal into Furnace in Power Plant Based on Radial Basis Function Neural Network , through analysis of furnace coal combustion product , using the quality equilibrium of fuel and the monitoring of firing conditions .

    通过分析电厂锅炉燃煤的燃烧产物,利用产物与燃料之间的质量平衡以及对燃烧条件的监测,建立了基于径向基函数(RBF)神经网络的电厂入炉煤元素分析软测量模型。

  14. Carbon dioxide is a primary combustion product of carbonaceous propellant and the close attention has been paid on studying its radiative properties . But some of today 's narrow band model parameters are obtained by fitting to experimental data and the spectral resolution is too low ;

    二氧化碳是含碳类推进剂主要的燃烧产物,其辐射特性的研究一直受到国内外重视,但其现有的窄谱带模型数据不完整或分辨率太低。

  15. The phase constitution and particle morphology of combustion synthesized product of Ti W C system were investigated .

    研究了TiWC体系燃烧合成产物相组成及颗粒形貌特征。

  16. Study on The Effect of Tungsten Content and Preheat Temperature on Combustion synthesized Product in Ti-W-C System

    W含量及预热温度对Ti-W-C体系燃烧合成产物的影响研究

  17. The effect of W content and preheat temperature on phase components and powder size of combustion synthesized product in Ti W C system were studied .

    研究了W含量及预热温度对Ti-W-C体系燃烧合成产物相组成及粉末形貌的影响。

  18. The effects of Al_2O_3 content to product phase were studied , the results show that : in the Al-Al_2O_3-N_2 system , the combustion synthesis product is made up with AlON , free Al and AlN ;

    研究了Al2O3含量对产物相组成的影响,结果表明:在Al-Al2O3-N2体系中,燃烧合成产物由AlON、未参加反应的自由Al和反应生成的AlN组成;

  19. The product was characterized by IR , UV . Combustion heat of product is 3181.75 kJ / mol , which unpuzzle strong exothermic phenomenon in reaction .

    用IR,UV表征了产物。测定了产物的燃烧热为3181.75kJ/mol,解释了反应过程中的强放热现象。

  20. Study on the Influence of Sustained Powdered-coal Combustion Technology on NO_x Product in Large Boiler

    大型锅炉煤粉稳燃技术对NOx生成影响的研究

  21. Hydrogen energy is universally acknowledged clean . It only consumes Oxygen to combustion and the sole product is water .

    氢能是公认的清洁能源,它的燃烧只消耗氧气并且只生成唯一的产物&水。

  22. Since hydrogen has the characteristics of high energy , high combustion rate , sufficient source and clean combustion product , in the future , it may become an important secondary energy .

    由于氢元素具有高能量、高燃烧率、来源充足,以及燃烧生成物无污染的特性,在未来有可能成为一种举足轻重的二次能源。

  23. The combustion chamber was divided into four sections such as basic atomization section , gas mixture circumfluence section , combustion section and gas product section . Combustion instability was essentially depended to pressure and geometrical parameter of combustion chamber and parameter of atomization nozzle .

    燃烧室分为基本雾化区、混合气回流区、燃烧区和燃烧产物区4个区,燃烧不稳定性主要与燃烧室压力、燃烧室几何参数、雾化喷嘴的工作参数等有关。